Vehicles after change point in 1982
REMOVING AND INSTALLING
LEFT OR RIGHT STRUT
Remove front wheel - see 36 10 300.
Unscrew bolt (2).
Lift off tie rod arm on spring strut.
Installation:
Clean threads in tapped bores and on bolts.
Install bolts with bolt cement**.
Tightening torque*.


Siehe auch 36 10 300
Siehe auch * See Specifications of Gr. 31/32
Siehe auch ** Source: HWB
2031013 - click to zoom
 
Check for correct installed position.

2832557 - click to zoom
 
Remove cotter pin and unscrew castle nut.
Press off ball joint with Special Tool 31 1 110.
Installation:
Clean bore to remove grease and dirt.
Tightening torque*.
Lock nut with a cotter pin.


Siehe auch * See Specifications of Gr. 31/32
2831024 - click to zoom
 
Unscrew strut on mount.
Installation:
Struts are marked.
L = left
R = right
Replace self-locking nuts.
1 = Washer (both sides)
Tightening torque* for a car in normal position*.


Siehe auch * See Specifications of Gr. 31/32
2831040 - click to zoom
 
Checking Strut Mounts:
Car in normal position*.
Measure distance between rubber mount and centering sleeve.
A mount marked with beads and a dot of green paint must be installed.


Siehe auch * See Specifications of Gr. 32
2831031 - click to zoom
 
A = 0.8 to 1.8 mm (0.031 to 0.071").
If measured distance is smaller or greater, replace strut mount - see 31 12 147.
N = rubber beads and green paint dot.


Siehe auch 31 12 147
2831041 - click to zoom