REMOVING AND INSTALLING CLUTCH HOUSING
Remove and install transmission 23 00 020.
Remove guard.


Siehe auch 23 00 020
63021016 - click to zoom
 
Unscrew bolts and remove clutch housing.

63021017 - click to zoom
 
Vehicles after change point in 1982
REMOVING AND INSTALLING
CLUTCH HOUSING
Remove transmission 23 00 022.
Cars with DME:
Remove heat shield.
Unscrew bolts (1 and 2).
Pull out speed sensor (3) and reference mark sensor (4).


Siehe auch 23 00 022
73021020 - click to zoom
 
Important!
Installation:
Check installed position.
Plugs must not be mixed up.
Install speed sensor (3) in bore (D) and reference mark sensor (4) with ring (5) in bore (B).
Engine cannot be started if plugs are mixed up.

73021021 - click to zoom
 
Installation:
Check O-rings.
Install sensors with Molykote Longterm 2.
Important!
Face surface of DME sensors must be free of grease and dirt.

73021022 - click to zoom
 
Unscrew clutch housing.
Use a Torx socket** to unscrew Torx bolts.
Improtant!
Installation:
Torx bolts must be installed with washers to avoid an increase in
breaking-loose torque.
Tightening torque*.


Siehe auch * See Specifications
Siehe auch ** Source: HWB
2821006 - click to zoom