Vehicles after change point in 1982
REMOVING AND INSTALLING/
REPLACING ONE REAR
PULSE (SPEED) SENSOR FOR
ABS
Turn off ignition.
Remove rear wheel 36 10 300.
Remove rear brake caliper 34 21 220.
Unscrew socket head screw.
Installation:
Distance* between pulse sensor and pulse wheel
(A) is given by design and cannot be adjusted.
However, pulse wheel has to be visually inspected
for dirt of damage.


Siehe auch 36 10 300
Siehe auch 34 21 220
Siehe auch * See Specifications
2834066 - click to zoom
 
Lift out wire and pull out pulse sensor.
Check seal (1), replacing if necessary.
Installation:
Lubricate pulse sensor and housing with
Molykote Longterm 2 before installing.

2834067 - click to zoom
 
Replacing Rear Pulse Sensor:
Take wires out of clips.
Pull out rubber grommet and wires.
Disconnect contact plug.
Detach pulse sensor.
Important!
Do not damage rubber grommet.

2834068 - click to zoom
 
Removing and Installing/Replacing Rear ABS
Pulse Wheel:
Pulse wheel is integrated in drive flange.
See "Replacing Wheel Bearings and Shaft Seals"
- 33 41 151.


Siehe auch 33 41 151