Vehicles after change point in 1982 REPLACING WHEEL BEARINGS AND SHAFT SEALS Disconnect output shaft at drive flange and tie up. Remove and install rear brake disc. |  |
Remove lockplate. |  |
Apply Special Tool 33 4 000. Unscrew collar nut. Pull off drive flange with Special Tool 00 7 501 and 00 7 502. |  |
Screw on collar nut flush with end of shaft and knock out with a nylon hammer. Installation: Check spline. Check drive flange, replacing if necessary. |  |
Remove circlip. |  |
Pull out wheel bearings with Special Tools 33 4 031, 33 4 032 and 33 4 038. |  |
Apply Special Tool 33 4 033. |  |
Pull inner bearing shell off of rear axle shaft with Special Tool 00 7 500. |  |
Pull in wheel bearing assembly with Special Tools 33 4 036, 33 4 032 and 33 4 038. |  |
Apply Special Tool 33 4 037. |  |
Install circlip. | |
Pull in rear axle shaft with Special Tools 33 1 300, 33 4 080 and 33 4 020. |  |
 |
|
Knock in lockplate with Special Tools 33 4 060 and 00 5 000. |  |
|
* See Specifications