Vehicles before change point in 1982
REMOVING AND INSTALLING
REAR AXLE CARRIER ASSY:
Remove and install parking brake lever 34 41 000.
Remove and install primary and final mufflers
18 12 000.
Draw off brake fluid through brake fluid tank
with a syringe reserved for this purpose.
Installation: Adjust parking brake 34 10 014.


Siehe auch 34 41 000
Siehe auch 18 12 000
Siehe auch 34 10 014
63034025 - click to zoom
 
Lift car on platform.
Pull parking brake cables out of protective tube.
Detach propeller shaft and brake lines.
Disconnect plug for pad wear indicator on right
caliper.
Remove wires from wire clips on trailing arm.
Installation: Bleed rear wheel brakes.
Tightening torque¹).


Siehe auch ¹) See Specifications
63033082 - click to zoom
 
Lower car until rear wheels are on shop floor.
Support rear axle carrier and final drive from
underneath with a floor jack.
Place a wooden beam on floor jack to help.
Detach final drive at rubber mount.
Installation: Tightening torque¹).


Siehe auch ¹) See Specifications
63033083 - click to zoom
 
Detach struts.
Installation: Tightening torque¹).


Siehe auch ¹) See Specifications
63033084 - click to zoom
 
Detach spring strut absorber at trailing arm.
Installation: Tighten bolts with car in normal
position¹).


Siehe auch ¹) See Specifications
63033085 - click to zoom
 
Lift car.
Run out rear axle.

63033086 - click to zoom
 
Vehicles after change point in 1982
REMOVING AND INSTALLING
REAR AXLE CARRIER ASSY.
Remove and install primary and final muffler
assembly 18 12 012.
Remove and install propeller shaft assembly
26 11 000.
Remove and install parking brake lever.
Draw off brake fluid through tank with a
syringe used exclusively with brake fluid.
Remove float housing for this purpose.
Installation:
Add brake fluid* and bleed brakes.


Siehe auch 18 12 012
Siehe auch 26 11 000
Siehe auch * See Specifications
63034150 - click to zoom
 
Unscrew left and right brake lines.
Installation:
Tightening torque*.


Siehe auch * See Specifications
2033039 - click to zoom
 
Support final drive with floor jack.
Detach left and right push struts at floor plate.
Unscrew nut on mount.
Installation:
Tightening torque*.


Siehe auch * See Specifications
2833006 - click to zoom
 
Pull off wires on speedometer pulse transmitter.
Unscrew mounting bolt on rubber mount.
Installation:
Tightening torque*.


Siehe auch * See Specifications
2833005 - click to zoom
 
Detach left and right spring struts at trailing
arms.
Lower rear axle carrier.
Pull parking brake cables out of tube.
Installation:
Tighten mounting bolts with loaded wheels
(car lowered).
Tightening torque*.


Siehe auch * See Specifications
2833008 - click to zoom