Vehicles after change point in 1982
REPLACING CONSTANT
VELOCITY JOINT FOR
PROPELLER SHAFT
Remove propeller shaft assembly - see 26 11 000.
Remove hose clamp.


Siehe auch 26 11 000
2826102 - click to zoom
 
Remove circlip.
Installation:
Replace circlip.

2826103 - click to zoom
 
Pull off constant velocity joint complete with dust cover.

2826104 - click to zoom
 
Press knurled head bolts and washers out of constant velocity joint.

2826105 - click to zoom
 
Press off dust cover.

2826106 - click to zoom
 
Pack new constant velocity joint with 60 grams of grease*.
Note:
Do not cant inner race with cage, since balls would fall out.


Siehe auch * Source: HWB
2826107 - click to zoom
 
Place gasket in shoulder provided for this purpose.
Press on the dust cover.
Installation:
Check that bores are located correctly.

2826108 - click to zoom
 
Press in knurled head bolts with washers.

2826109 - click to zoom
 
Clean splines to remove grease and then coat with a bolt cement*.
Important!
Keep bolt cement out of ball paths.


Siehe auch * Source: HWB
2826110 - click to zoom
 
Drive constant velocity joint on propeller shaft with Special Tool 23 1 040.

2826111 - click to zoom
 
Insert circlip.
Note:
Check for correct and tight fit.

2826112 - click to zoom
 
Install hose clamp on dust cover.

2826102 - click to zoom
 
Constant Velocity Joint Assembly
1 Transport cap
2 Circlip
3 Constant velocity joint
4 Gasket
5 End cover
6 Dust cover
7 Propeller shaft
8 Bolt
9 Washer

2826100 - click to zoom