Vehicles before change point in 1982
REMOVING AND INSTALLING TORQUE CONVERTER
Remove and install transmission 24 00 020.
Pull torque converter out of primary pump
carefully with Special Tool 24 4 000.
Important: Escaping ATF!


24 00 020

Installation: Check torque converter for leaks
with Special Tool 24 4 041 used in conjunction
with Special Tools 24 4 043 adn 24 2 062.
Test pressure is 0.5 bar (7 psi).
Important: Use retainer to prevent injuries.

If converter shaft bearing surface is damaged,
replace torque converter.

If stator (L) or turbine (T) can´t be turned by
hand, replace torque converter.

Guide openings of torque converter into primary
pump by turning carefully with Special Tool
24 4 000.
Important: Be careful that converter bearings
and seals are not damaged while installing.
Converter is installed correctly, if drive dogs (A)
are about 9 mm (0.354´´) below edge of case.