Vehicles after change point in 1982
REMOVING AND INSTALLING
VALVE BODY
Remove oil sump - see 24 11 000.
Remove oil filter screen.
Installation:
Tightening torque*.
Check length of bolts.
Bolts with conical bolt head = 65 mm (2.559´´)
long.


Siehe auch 24 11 000
Siehe auch * See Specifications
73324083 - click to zoom
 
Remove valve body.
Unscrew Torx bolts with Special Tool
00 2 100.
Important!
Only unscrew bolts with bolt head size A =
12 mm.
Installation:
Bolts differ in length.
Bolts (1) = 65 mm (2.559´´) long.
Bolts (2) = 60 mm (2.362´´) long.

73324273 - click to zoom
 
Installation:
Tighten Torx bolts with Special Tools
00 2 100 and 00 2 050.
Tightening torque*.


Siehe auch * See Specifications
73324085 - click to zoom
 
Installation:
Mount valve body that clamp on selector valve
can be connected in operating finger of pawl.
This requires pulling transmission cable
slightly so that throttle cam (2) cannnot clamp
on throttle pressure valve (3).

73324086 - click to zoom
 
Install valve body and screw in bolts only
finger tight.
Align valve body with Special Tool 24 3 050.
If special tool is not available, check that distance
from valve body case to pin of throttle
pressure piston is 11.5 mm (0.453´´).
Tighten valve body bolts.

73324087 - click to zoom
 
EH Transmission:
Turn bayonet fatener (1) to the left.
Pull off plug (2).
Unscrew nut (3).
Installation:
Connect plug (2) in such a manner that marking
lines are aligned.

73324248 - click to zoom
 
Pull out socket toward inside.
Installation:
Check O-ring (4), replacing if necessary.
Plug in socket with flat side facing out.
Tightening torque*.


Siehe auch * See Specifications
73324249 - click to zoom
 
Note:
Also mount pulse transmitter on the valve body.
Tabs on holder (5) must engage in grooves of
plug.

73324250 - click to zoom