Vehicles before change point in 1982
REMOVING AND INSTALLING VALVE BODY
Remove oil pan 24 11 000.
Remove valve body.
Important: Watch support (1).
Only for Version with Support Plates:
Also secure support plates (1).


24 11 000

Version with Torx Bolts:
Tighten Torx bolts with Special Tools 00 2 100
and 00 2 050¹).


¹) See Specifications for tightening torque

Installation: Install valve body that clamp on
selector sliding valve can be engaged in operating
arm of pawl.
This requires tightening transmission cable
somewhat, so that accelerator cam (2) can´t jam
with throttle pressure valve (3).

Tighten valve body bolts finger tight.
Align valve body with Special Tool 24 3 050.
If tool is not available, check that distance from
valve body housing to pin in throttle pressure
piston is 11.5 mm (0.453´´).
Tighten valve body bolts.

Identification stamped on valve body:
Version with Flat Oil Pan =
BMW 630 CSi 007
Version with Deep Oil Pan =
BMW 630 CSi 032
BMW 633 CSi 033 or 047

Vehicles after change point in 1982
REMOVING AND INSTALLING
VALVE BODY
Remove oil pan 24 11 000.
Remove valve body.


24 11 000

Installation:
Tighten Torx bolts to specified torque* with
Special Tools 00 2 100 and 00 2 050.


* See Specifications

Installation:
Position valve body that clamp on selector
valve can be attached in operating arm of pawl.
Pull transmission cable slightly for this purpose
so that accelerator cam (2) does not clamp on
throttle pressure valve (3).

Tighten valve body bolts only finger tight.
Align valve body with Special Tool 24 3 050.
If this special tool is not available, distance from
valve body case to pin in throttle pressure piston
should be 11.5 mm (0.453´´).
Tighten valve body bolts.