REMOVING AND INSTALLING RADIATOR
Open cap on expansion tank.
Disconnect wire plugs (1 ... 4) at temperature
switch.
Installation:
1 = 2 green/red wires (wide plug)
2 = 1 green wire (narrow plug)
3 = 1 green/black wire (narrow plug)
4 = 2 green/black wires (wide plug)

Detach radiator hose and drain coolant.
Installation: Fill and bleed cooling system
17 00 039.


17 00 039

Detach and remove upper hoses.
Unscrew fan shroud and mounting bolt.

Cars with Automatic Transmission:
Unscrew oil feed line (7) and return line (8).
Important: Escaping ATF!
Installation: Blow out transmission oil cooler in
side radiator section with compressed air immediately
after removal and flush with ATF.

Unscrew fan shroud mounting bolt.
Detach support and remove radiator.
Installation: Holding land must be pressed on
holding land of radiator.

Lift fan housing out of slots in radiator and rest
it on fan wheel.
Installation: Guide fan housing into slots.

Installation: Check rubber liners and replace
them if necessary.

Vehicles after change point in 1982
REMOVING AND INSTALLING
RADIATOR
Unscrew cap on expansion tank.
Unscrew drain plug (1) and drain coolant.
Loosen hose clamp and pull off hose.
Caution!
Danger of scalding when engine is hot.

Installation:
Tightening torque* for drain plug.
Use new hose clamp.
Add coolant** and bleed cooling system 17 00 039.


* See Specifications
17 00 039
** See Service Information of Gr. 00

Pull off plugs on temperature switches.

Unscrew bolts (1).
Loosen hose clamp and pull off hose.

Cars with Automatic Transmission:
Unscrew oil line on radiator.
Installation:
Tightening torque*.
Check ATF level, see 24 00 009.


* See Specifications
24 00 009

Unscrew mounting bolts on left and right sides.
Lift out radiator.
Installation:
Position radiator on rubber mounts correctly.