Vehicles after change point in 1982
REPLACING RADIAL OIL SEAL
IN CLUTCH END COVER
- Transmission Removed -
Remove flywheel - see 11 22 000.
Drain engine oil.
Loosen oil pan.
Loosen gasket at end cover/oil pan joint carefully with a knife.
Unscrew end cover.
Press radial oil seal out of end cover.
Installation:
Replace gasket.
If oil pan gasket was damaged, remove oil pan - see 11 13 000.
Apply coat of Three Bond Silicone 1207** on end cover/oil pan joint.
Use Special Tool 11 2 213 to avoid damaging the radial oil seal.
Pour in engine oil***.


Siehe auch 11 22 000
Siehe auch 11 13 000
Siehe auch ** Source: HWB
Siehe auch *** See Service Information of Gr. 00
3011026 - click to zoom
 
Use Special Tools 11 1 260 and 00 5 500 to press in the radial oil seal.
Press in the new radial oil seal to a depth of approx. 1 to 2 mm (0.039 ... 0.079"), in
contradiction to the standard seal which had been pressed in flush.
Lubricate sealing lip with oil.

3011027 - click to zoom