REPLACING RADIAL OIL SEAL IN END COVER (CLUTCH END)
Remove flywheel 11 22 000.
Drain engine oil.
Loosen oil pan.
Loosen gasket with a knife carefully in area of
end cover/oil pan joint.
Take off end cover.
Replace seal.
If oil pan gasket was damaged, remove oil pan 11 13 000.
Installation: Coat end cover/oil pan joint surfaces
with Atmosit or Curil K 2.
Use Special Tool 11 2 213 to prevent damage on
the radial oil seal.


11 22 000
11 13 000

Press in radial oil seal with Special Tools
11 1 260 and 00 5 500.
Lubricate sealing lip of radial oil seal with oil.

Vehicles after change point in 1982
REPLACING RADIAL OIL SEAL
IN CLUTCH END COVER
- Transmission Removed -
Remove flywheel 11 22 000.
Drain engine oil.
Loosen oil pan.
Pry off gasket carefully with a knife in area of end cover/oil pan joint.
Take off end cocer.
Replace gasket.
If oil pan gasket was damaged, remove oil pan 11 13 000.
Installation:
Coat end cover/oil pan joint with a brush-on universal sealing compound/
Three Bond Silicone 1207**.
Use Special Tool 11 2 213 to avoid damaging the radial oil seal.


11 22 000
11 13 000
** Source: HWB

Press in radial oil seal with Special Tools 11 1 260 and 00 5 500.
Press in new radial oil seal approx. 1 to 2 mm (0.039 to 0.079"), in contradiction
to the standard radial oil seal which had been pressed in flush.
Lubricate sealing lip with oil.