Vehicles after change point in 1982
CHECKING OR REPLACING
CONTROL UNIT FOR POWER
ANTENNA
Remove antenna - 65 22 005.
Open antenna cover with Special Tool 65 2 100.


Siehe auch 65 22 005
2865558 - click to zoom
 
Note:
The antenna assembly is mounted with rubber pads between the housing and
cover; make sure of correct position when assembling.

2865556 - click to zoom
 
Replacing:
Remove control unit.
Pull off plug and connect on new control unit.

2865559 - click to zoom
 
Note:
1 = red
2 = green (electric motor)
3 = red (electric motor)
4 = white
5 = black

2865557 - click to zoom
 
Checking:
Malfunction - antenna does not run out/in even though radio had introduced
activation (white wire on antenna wire harness).
Pull off wires (red and green) leading to the electric motor on the control unit.
Connect red wire on power (approx. 12 V) and green wire
on ground - antenna runs out.
Connect green wire on power (approx. 12 V) and red
wire on ground - antenna runs in.
Replace control unit, if the above mentioned conditions are fulfilled.