INSTALLING AUTOMATIC ANTENNA
Disconnect battery ground.
Unscrew screws and take off trim.

Pull off wires on automatic cut-out for electric
windows.

Detach and attach instrument panel trim at
bottom left 51 45 180.
Loosen screws and take off left front wheel house
trim.


51 45 180

Drill a 20 mm (0.787´´) dia. hole at front of left
side panel.
Distance A = 70 mm (2.756´´)
Distance B = 19 mm (0.748´´)
Apply a coat of zinc paint on edges of hole.

Press out plastic plug from pre-punched holes.

Mount bracket on automatic antenna.

Mount bracket on threaded pins provided in
front wheel house.

From 1978 Models:
Mount bracket on automatic antenna.

Install rubber grommets on antenna and control
wires with their beads facing passenger compartment.
Installed Order of Mounting Parts:
1 ... 4 outside on side panel.
5 ... 8 inside in wheel house
Engage toothed ring (6) with two shoulders in
openings of adapter (7).

From 1979 Models:
Place rubber grommets, with beads facing passenger
compartment, on antenna and control wires.
Installed Order of Mounting Parts:
1 ... 4 outside on side panel
5 ... 9 inside in wheel house

Insert antenna wire through upper hole and control
wire through lower hole, install rubber grommets
and mount antenna on holder.

From 1979 Models:
Insert antenna wire through upper hole and control
wire through lower hole, install rubber grommets
and mount antenna on wheel house (don´t
tighten nut at this point).

Install and tighten upper mounting parts.
Tighten antenna at bottom on wheel house.

Route antenna wire and (white) control wire to
place of radio installation.
Remove radio, if applicable.
Connect wire (1) and wire (2) on radio.

Connect (red) power wire on plug terminal
connection with red/yellow wire mark.

Mount (black) ground wire at ground point.
Install all removed parts.