REMOVING AND INSTALLING ELECTRIC WINDOW
CONTROLS IN FRONT DOOR
Detach and attach door trim - 51 32 020.
Pull off Acella plastic sheet.
Detach door window glass at front window
guide.


Siehe auch * See Specifications
63051114 - click to zoom
 
Unscrew upper screw (1) and lower screw (2).
Remove front window guide.

63051115 - click to zoom
 
Take window winder off of door.

63051116 - click to zoom
 
Detach lifting arm for large bore at lifting
rail.

63051083 - click to zoom
 
Installation: Lifting rail must run between
both plastic washers.
Coat detent of window winder with a
multi-purpose grease.

63051084 - click to zoom
 
Remove electric window controls downward
and disconnect wires.

63051117 - click to zoom
 
Installation:
(1) = Black wire
(2) = Blue wire

63051118 - click to zoom
 
Installation: When door window is closed
stop (1) must limit the window´s upward
movement.
Door window glass must not be under
tension.

63051119 - click to zoom
 
From 1079 Models:
Detach door window at front window guide.

63051241 - click to zoom
 
Unscrew rear screw.
Push up door window glass and hold tight.

63051243 - click to zoom
 
Detach window guide rail at top.

63051244 - click to zoom
 
Detach window guide rail at bottom and
remove.

63051245 - click to zoom
 
Move window regulator to center position.
Unscrew rear screw.

63051246 - click to zoom
 
Unscrew front screws.

63051247 - click to zoom
 
Pull off wires on window motor.
Remove window regulator.
Installation:
1 = black wire
2 = blue wire

63051248 - click to zoom
 
Installation: Not the rubber door strip, but stop
(1) should limit the upward movement of the
door window glass.
Door window glass should not have stress.

63051242 - click to zoom
 
Vehicles after change point in 1982
REMOVING AND INSTALLING
ELECTRIC WINDOW REGULATOR
IN FRONT DOOR
Should the electirc window regulator fail, door
window can be operated manually.
Remove cover.
Screw in hexagon socket and turn emergency
control in desired direction with a spark plug
wrench.

63051249 - click to zoom
 
Disconnect battery ground lead.
Remove and install door trim panel 51 41 000.
Pull off Acella sheet.
Detach door window at front window guide.


Siehe auch 51 41 000
63051241 - click to zoom
 
Unscrew rear bolts.
Push up and hold door window glass.

63051308 - click to zoom
 
Remove front and rear door window guide rails.
Installation:
Adjust both window guide rails that door
window moves easily and rests firmly on rubber
door seal when closed.

63051275 - click to zoom
 
Move window regulator to center position.
Unscrew rear bolt.

63051246 - click to zoom
 
Unscrew front bolts.

63051247 - click to zoom
 
Pull off wires on electric window motor.

63051276 - click to zoom
 
Remove window regulator.

63051277 - click to zoom
 
Installation:
When door is closed the upward movement of
door window must not be stopped on rubber
door seal, but adjusted with stop (1).

63051242 - click to zoom