REPLACING TRUNK LID LOCK SWITCH
Remove and install tail panel trim - 51 47 240.
Detach central plug from clamp.
Disconnect plug.


51 47 240

Unscrew screws (1 ... 2).
Detach holder on one side and remove switch.
Installation: Make sure that operating rod (3)
for central locking system is located in guide
provided for this purpose.

When installing a trunk lid lock switch, make
sure that impact switch (1) is turned on.

Note: If car is involved in a collision, impact
switch automatically unlocks all locks.
System is reset by pressing down on safety
button of impact switch (accessible after
opening glove box) and also pressing down
catch button (2) of driver´s door.

Vehicles after change point in 1982
RREPLACING SWITCH (DIRVE)
FOR LOCK OF TRUNK LID
Lift out clips for trim panel.
Fold trim panel forward.

Disconnect linkage.
Unscrew screws (1).
Unscrew drive (2).
Installation:
Check codes of drives - see 51 26 000.


51 26 000

Installation:
1. Turn lock to LOCKED position.
2. Attach drive in connecting linkage and hold
with a screw (screw is not tightened).
3. Tighten screws (1).
4. Screw in a second screw.
Compress drive (position A), pull down
slightly (linkage clearance) and tighten
screw with 2 Nm (1.5 ft.lbs.) torque.
5. Tighten the screw installed first.