Vehicles before change point in 1982
REMOVING AND INSTALLING FRONT BRAKE PADS
Remove and install front wheels - 36 10 300.
Only disconnect front left plug for pad wear
indicator and take wires out of clamp.
Drive out retaining pins and remove cross
spring (1).
Installation: Check cross spring and retaining
pins, and replace them if necessary.


Siehe auch 36 10 300
63034113 - click to zoom
 
Pull out brake pads with Special Tool 34 1 010,
or knock out jammed brake pads with Special
Tool 34 1 000.
Important: Mark location of used brake pads.
If brake pad wear is one-sided, do not mix up
brake pads.

63034115 - click to zoom
 
Installation: Check guard plates between
piston and back of brake pads, replacing if
necessary.
Guard plates can be installed retroactively.

63034132 - click to zoom
 
Installation: Note minimum thickness (A)¹).
Brake pads must move easily in caliper.


Siehe auch ¹) See Specifications
63034131 - click to zoom
 
When Replacing:
Use repair kit.
Important: Brake pads must always be
replaced on both calipers of one axle at the
same time.
Note color code (B)¹) and make¹).


Siehe auch ¹) See Specifications
63034023 - click to zoom
 
Important: Install a new wear sensor in front
left side of right brake pad.
Installation: Thicker side of wear sensor faces
brake disc.

63034024 - click to zoom
 
Clean guide surface and seat in housing
opening with a cylindrical brush.
Never use any mineral oil type cleaning
solution.
New brake pads must move easily in caliper.

63034110 - click to zoom
 
Press piston into caliper up to stop with
Special Tool 34 1 050.
Install brake pads.
Installation: Note brake fluid in tank.
Pump brake pedal to move brake pads
against disc.
Important: Break in new brake pads during
first 600 km (400 miles). Avoid violent stops
from top speeds. Non-conformance will prevent
brake pads from reaching their most favorable
wear and friction values.

63034116 - click to zoom
 
Vehicles after change point in 1982
REMOVING AND INSTALLING
FRONT BRAKE PADS
Remove and install front wheels 36 10 300.
Pry off plastic caps (1).
Pull off plug for brake pad wear indicator on
left side.


Siehe auch 36 10 300
2034014 - click to zoom
 
Unscrew guide bolts (2).
Installation:
Only clean guide bolts - don´t lubricate.
Check guide bolts for condition, renew if
necessary.
Tightening torque*.


Siehe auch * See Specifications
63034158 - click to zoom
 
Press out clamp (3).
Pull off brake caliper toward front.

2034016 - click to zoom
 
Remove outer brrake pad.
Inner brake pad is located in piston with
spring (4).
Installation:
Check pad thickness*).
Renew brake pads always on both calipers
of one axle.
Note:
Make *) of pads.


Siehe auch * See Specifications
63034206 - click to zoom
 
Installation:
Press piston back completely.
Clean brake pad guides and recesses, with
a special brush **).
Check dust cover for damage.


Siehe auch **) See BMW Handels & Werkstättenbedarf
73034180 - click to zoom