Vehicles after change point in 1982
REPLACING CONTACT RING (SRS)
Caution!
Conform with safety regulations!
Improper handling could cause unwanted
activation of SRS and in turn lead to injury!
Remove steering wheel - see 32 33 000.


32 33 000

Pull off casing.
Installation:
Lubricate the horn slip ring with grease.

Mark position of the circlip to the hub.
Unscrew three studs.
Press the circlip down, turn and remove it.

Installation:
Place the circlip in the hub, turn and pull it
up.
The studs must be in the openings of the
circlip.

Lift out lock with a screwdriver.
Installation:
Connect spring on the lock and insert it in the
bore.
Press the lock down until it engages.

Disconnect plug.
Unscrew the screw and take off the contact
ring.

Important!
A new contact ring is held in the center position
with a screw.
Remove this screw after screwing the contact
ring on the steering wheel.