Vehicles after change point in 1982
REPLACING SPRING STRUT
MOUNT
Remove spring strut assembly - see 31 31 000.
Clamp spring strut in a vise with Special Tool 31 3 000.


Siehe auch 31 31 000
2831005 - click to zoom
 
Apply Special Tool 31 3 116 on mount.

2831006 - click to zoom
 
Compress coil spring with Special Tool 31 3 111.
Important!
Bolts on mount and Special Tool 31 3 116 must fit in openings.

2831007 - click to zoom
 
Pull off end cap.
Unscrew self-locking nut with Special Tool 31 3 170, counterholding on the piston rod.
Installation:
Replace self-locking nut.
Tightening torque*.


Siehe auch * See Specifications of Gr. 31
2031048 - click to zoom
 
Remove washer (2).
Screw in Special Tool 31 3 115 entire length of threads.
Release and remove coil spring compressor tool.

2831020 - click to zoom
 
Lift off mount.
Installed Order:
1 Self-locking nut
2 Washer with small diameter
3 Mount
4 Insulator
5 Washer with large diameter
6 Cap
Inside curved surface of insulator (4) faces mount.

2031045 - click to zoom
 
Lift off upper spring retainer with rubber ring and coil spring.
Installation:
Check upper and lower rubber rings, replacing if necessary.
Ends of coil spring must fit on shoulders in lower and upper spring retainers.

73031057 - click to zoom
 
Important!
If a correction mount was installed, a mount with the same identification must
be installed.