Vehicles after change point in 1982 REPLACING CABLE FOR
RANGE SELECTOR LEVER
Remove and install tray 51 16 200.
Loosen nut.
Important!
Don't bend the steel wire.


Siehe auch 51 16 200
2025035 - click to zoom
 
Unscrew nut.
Push back cable sleeve and disconnect on holder.
Pull cable out of operating lever.

2025048 - click to zoom
 
Installation:
Check arrangement of washers.
Check rubber mount, replacing if necessary.

2025049 - click to zoom
 
Lift out retainer.
Unscrew eye on bolt.
Important!
Don't bend the steel wire.

2025036 - click to zoom
 
Unscrew nut.
Disconnect cable sleeve on holder.

2025037 - click to zoom
 
Cut and fold in carpet.

2025050 - click to zoom
 
Pull out rubber grommet with cable.

2025051 - click to zoom
 
Installation:
Guide in cable from above.
Knock in rubber grommet.
Note:
Recheck fit of rubber grommet after finishing installation of the cable.

2025052 - click to zoom
 
Installation:
Adjust cable.
Selector lever in "P" (position furthest forward).
Transmission lever in "P" (position furthest forward).
Press cable pull rod opposite forward direction.
Bolt down cable pull rod without tension.
Important!
Tightening torque: 10 to 12 Nm (7 to 9 ft. lbs.).
Don't bend the cable.

2025053 - click to zoom