 |
|
Pull out selector lever base and remove washer as well as bearing bushings. Installation: Lubricate bearing bushings with Longterm 2. |  |
Detach wires at selector lever upper section and plugs at base. |  |
Unscrew transmission switch mounting screw and remove transmission switch together with selector lever upper section from base. Installation: Watch operator/transmission switch position. |  |
Pull selector rod with spring out of selector lever upper section. |  |
Vehicles after change point in 1982 REMOVING AND INSTALLING SELECTOR LEVER - Version with Shift Rod - Remove selector lever complete with base - see 25 16 050. Drive out pin.  25 16 050
|  |
Pull out selector lever lower section. Remove washer (1) and bearing sleeves (2). Installation: Check bearing sleeves, replacing if necessary and lubricating with Molykote Longterm 2. |  |
Pull off plug (3). Unscrew screw (4). Remove transmission switch together with the upper selector lever section. |  |
Installation: Check installed position of transmission switch and drive. |  |
Unscrew screw on handle. Pull off handle. |  |
Installation: Guide pin of push button into pull rod hole. |  |
Take pull rod out of selector lever upper section. |  |
Installation: Check gate, replacing if necessary. |  |
