REPLACING RADIAL OIL SEAL FOR OUTPUT FLANGE
Remove exhaust assembly 18 00 020.
Version with Heat Shield:
Detach heat shield at body and propeller shaft.
Use Special Tool 26 1 011 for removal and
installation of propeller shaft to prevent stress in
Giubo coupling and therefore vibration and
drumming.
Unscrew bolts.
Installation: Use stop nuts only once.


Siehe auch 18 00 020
73023027 - click to zoom
 
Tighten Special Tool 26 1 011 until bolts can
be pulled out by hand.

73023028 - click to zoom
 
Installation: Tighten nuts to specified torque¹)
with a standard 19 mm socket and torque
wrench.
Important: Only tighten nuts (never bolts) to
prevent stress in Giubo coupling.
Remove special tool strap only after tightening nuts.


Siehe auch ¹) See Specifications
63023085 - click to zoom
 
Remove heat shield.
Detach center bearing bracket.
Bend down propeller shaft and pull it off of
centering pin.
Installation: Preload center bearing bracket in
forward direction by 2 mm (0.080´´) = (A).

63023013 - click to zoom
 
Support transmission.
Remove cross member.

63023031 - click to zoom
 
Install Special Tool 23 1 200.
Hold output flange with Special Tool 23 1 150
and unscrew collar nut¹) with Special Tool
23 1 210.


Siehe auch ¹) See Specifications for tightening torque
63023032 - click to zoom
 
Pull off output flange with Special Tool 33 1 150.

63023086 - click to zoom
 
Pull out radial oil seal with Special Tool 00 5 000.

63023033 - click to zoom
 
Installation: Lubricate sealing lip with oil.
Knock in radial oil seal flush with Special Tool
23 1 370.

63023034 - click to zoom
 
Attach output flange.
Install collar nut¹) with Loctite No. 270.
Lock lockplate in groove of output flange.


Siehe auch ¹) See Specifications for tightening torque
73023022 - click to zoom