Vehicles after change point in 1982
REMOVING AND INSTALLING/SEALING COVER
WITH GUIDE TUBE FOR CLUTCH RELEASE
Unscrew cover.
Important!
Spacers.
Inportant! - Installation:
Check length of bolts.
Bolts (1 ... 3) = 8 x 30 mm.
Bolts (4 ... 7) = 8 x 22 mm.

Adjust ball bearing between input shaft and
guide flange to 0 ... 0.09 mm (0 to 0.0035´´).
Measure distance (A) from case to ball bearing.@@K

Measure distance (B).
Example:
..B ...8.1 mm (0.319´´)
- A ...7.8 mm (0.307´´)
_________________
........0.3 mm (0.012´´) spacer thickness

Adjust roller bearing play between layshaft
and guide flange.
Measure distance (C) from case to roller bearing
outer race.

Measure distance (D).
Example:
..D......4.8 mm (0.189´´)
- C......4.3 mm (0.169´´)
__________________
...........0.5 mm (0.020´´)
- 0.1 ...0.2 mm (0.004 ... 0.008´´) axial play
_________________________
...........0.3 mm (0.012´´) spacer thickness

Coat sealing surfaces with Loctite No. 573.
Sealing surfaces must be cleaned thoroughly
and dried of oil.
Hold spacers of calculated thickness in position
with grease.
Mount cover.
Install bolts with Loctite No. 573.
Tightening torque*.
Threads cleaned to remove old cement.


* See Specifications