Vehicles after change point in 1982 INSTALLING EXCHANGE TRANSMISSION Remove transmission 23 00 022. Transmission Identification: BMW code* on front case section. Transmission Type 260.  23 00 022 * See Spare Part Microfiche
|  |
 |
|
Transfer spring (1) and release lever (2) with release (3). |  |
Installation: Fill lubricating groove (N) with Molykote Longterm 2. Lubricate guides (F) and bearings (L) with a light coat of Molykote Longterm 2. Non-conformance could cause bearing to seize on the guide sleeve. |  |
Transfer selector rod joint. Push back locking sleeve (1). Drive out dowel pin (2). Note: Check installed position of the selector rod joint. The offset end of the selector rod joint for a Type 260 transmission is installed on the right side as seen looking forward in car, while the offset end of the selector rof joint of a Type 265 transmission is installed on the left side. |  |
Transfer rubber mounts, exhaust carrier and backup light switch. Alter Installation of Transmission: Fill transmission with oil. Oil volume*. * See Specifications
|  |
