REMOVING AND INSTALLING CLUTCH MASTER CYLINDER
Remove instrument panel trim at bottom left.
Detach piston rod (1) at clutch pedal.
Installation: Engage TDC spring (2) in guide boss
(3) on pedal assembly base prior to attaching piston
rod (1).

73021014 - click to zoom
 
Loosen nut (1) and unscrew piston rod (2).
Installation: Adjust pedal travel¹) with piston
rod (2).
Important: Note whether bushings (3) are installed.
Coat bushings and pins with Molykote Longterm 2.

63021032 - click to zoom
 
Draw fluid out of brake fluid tank until level
drops to filling line connection.

63021033 - click to zoom
 
Pull out filling line.
Detach line (4) to slave cylinder.
Detach slave cylinder at engine firewall and take
out forward.
Installation: Bleed clutch 21 00 006.


Siehe auch 21 00 006
63021034 - click to zoom
 
Vehicles after change point in 1982
REMOVING AND INSTALLING
CLUTCH MASTER CYLINDER
Disconnect pipe (1) to slave cylinder.

2021004 - click to zoom
 
Unscrew cap on brake fluid tank.
Remove float container (2).
Draw off brake fluid in tank to lower level to connection for the filling pipe.

2821003 - click to zoom
 
Remove instrument panel trim at bottom left - see 51 45 180.
Disconnect piston rod (3) on the clutch pedal.
Installation:
Adjust the clutch pedal with eccentric bolt (7) - see Group 35.


Siehe auch 51 45 180
2021015 - click to zoom
 
Important! - Installation:
Engage over-center spring (8) in guide tab (9) on the pedal base prior to
installation of the piston rod (3).

3021007 - click to zoom
 
Pull out filling pipe (4).
Unscrew bolts (5 and 6).
Remove master cylinder.
Installation:
Bleed clutch - see 21 00 006.


Siehe auch 21 00 006
2021007 - click to zoom