REMOVING AND INSTALLING SUN ROOF MOTOR
Remove and install motor and gearbox for sun
roof 54 13 010.
Loosen screws (1 and 2).


Siehe auch 54 13 010
63054052 - click to zoom
 
Disconnect black wire (1) and blue wire (2) in
plug receptacle.
Remove flat motor.

63054053 - click to zoom
 
Install emergency winder (1) in gearbox.

63054028 - click to zoom
 
Remove trunk trim on body tail panel
51 47 240.
Turn emergency winder anticlockwise and run
out drive cable toward rear by about 45 mm
(1.772´´).


Siehe auch 51 47 240
63054036 - click to zoom
 
Detach guide tubes (1 and 2).
Pull off central plug (3).
Installation: Make sure that guide tubes are
positioned correctly.

63054054 - click to zoom
 
Loosen screws (1 ... 3) and remove gearbox.

63054055 - click to zoom
 
Installation: Adjust gearbox to basic position.
Mark (M) on large pinion must be opposite
outer edge of housing and pinion must engage
in bore (F).
Tighten gearbox screws.

63054056 - click to zoom
 
Attach guide tubes and central plug.
Important: Drive cable has a color mark.
Turn in drive cable up to center of color mark.
Install pinion in this position and attach cover
plate.

63054057 - click to zoom