Vehicles after change point in 1982
REMOVING AND INSTALLING
OR REPLACING DRIVE AND
GEARBOX FOR OUTER AND
INNER BACKREST CONTROL
- Front Seat Removed -
Take off reclining backrest mechanism trim.
Unscrew screw and remove gearbox.
Pull off connecting shaft.

73052045 - click to zoom
 
Installation:
Install axial bearing (1) with grease.
Insert gear (2) by turning.

73052046 - click to zoom
 
Install drive worm (3) on drive shaft and insert in gearbox case.
Collar of connecting shaft rests on case.

73052047 - click to zoom
 
Compress locking tabs and disconnect plug.
Pull plug out of plug receptacle with Special Tool (1)**.
Installation:
Connect plug (wires) that colors match.


Siehe auch ** Source: HWB
73052039 - click to zoom
 
Unscrew screws.
Pull connecting shafts out of drive and, if applicable, potentiometer.
If applicable, remove control unit (memory) with bracket.
Note:
Basic wire color for potentiometer connection is green.

73052049 - click to zoom