REPLACING/ADJUSTING PUSH ROD
FOR ACCELERATOR
Detach push rod at arm and reversing lever.

63035038 - click to zoom
 
Requirements:
Engine at operating temperature.
Stop engine and press down on accelerator
pedal against full throttle stop (past full
throttle stop for cars with automatic transmission).
Operating lever (1) must now rest on stop (2).
Correct by turning ball socket on push rod.

63035040 - click to zoom
 
Cars with Automatic Transmission:
Check adjustment of transmission cable.
The seal pressed on cable must have distance
(A) = 0.25 to 0.75 mm (0.010 to 0.030´´) from
cable stop in neutral.

63034041 - click to zoom
 
Check, whether with pedal floored (pressed
down past full throttle stop) transmission cable
is pulled out by at least distance A = 45 mm
(1.772´´).
Correct with adjusting screw, if necessary.

63035042 - click to zoom
 
LAYOUT ASSEMBLY DRAWING OF ACCELERATOR PEDAL
Installation: Adjust push rod.
Check full throttle stop screw (1), correcting to
distance C¹) if necessary.
Adjusting Accelerator Linkage:
Adjust length of pull rod (2) to L = 430 mm
(16.929´´).
Adjust push rod (3) by turning ball socket.


Siehe auch ¹) See Specifications
52535051 - click to zoom