Vehicles before change point in 1982
REMOVING AND INSTALLING STEERING GUIDE ARM
Remove and install exhaust assembly 18 00 020.
Remove cotter pin and unscrew castle nut.
Press center tie rod off of steering guide arm
with Special Tool 32 2 070.
Installation: Tightening torque¹).
Lock castle nut with cotter pin.


Siehe auch 18 00 020
Siehe auch ¹) See Specifications
63032053 - click to zoom
 
Unscrew nut (1) and pull out bolt (2) from
above.
Remove steering guide arm (3).
Installation: Coat both sides of face with diluted
Cresta, lubricating oil II or relaxed water
before installing.
Replace self-locking nuts.
Tightening torque¹).


Siehe auch ¹) See Specifications
63032152 - click to zoom
 
Installation: Check steering guide arm and
fluid block, replacing if necessary.
Distance A = 143.5 ± 0.5 mm (5.649 ± 0.020´´).

63032055 - click to zoom
 
Vehicles after change point in 1982
REMOVING AND INSTALLING
STEERING GUIDE ARM
Remove cotter pin and unscrew castle nut.
Press off ball joint with Special Tool
32 2 040.
Installation:
Tightening torque*.
Lock castle nut with cotter pin.
On new type replace
selflocking nut.


Siehe auch * See Specifications
2832552 - click to zoom
 
Remove steering guide arm.
1 = Washer
Installation:
Check fluid block, replacing if necessary.
Tightening torque*.


Siehe auch * See Specifications
2831039 - click to zoom