Vehicles before change point in 1982 REPLACING SELECTOR ROD Remove exhaust assembly 18 00 020. 1980 Models: Detach heat shield.  18 00 020
|  |
 |
|
To prevent stress in Giubo coupling and therefore vibration and drumming, use Special Tool 26 1 011 for removal and installation of propeller shaft. Unscrew bolts. Installation: Use stop nuts only once. |  |
Tighten Special Tool 26 1 011 until bolts can be removed by hand. |  |
Installation: To prevent stress in Giubo coupling only tighten nuts (never bolts). Tightening torque¹). Tighten nuts before removing special tool. ¹) See Specifications
|  |
Remove heat shield. |  |
Detach center bearing. Installation: Preload center bearing forward by distance (A) = about 2 mm (0.080´´). |  |
Bend down propeller shaft and pull out of centering pin on transmission. Important: Don´t disconnect propeller shaft at slide. |  |
Installation: Check center, lubricating with Longterm 2 if necessary. Replace a damaged center. |  |
Engage reverse gear. Remove circlip (1). Take off washer (2). Pull out selector rod (3). |  |
Push back locking sleeve (1). Move selector shaft to 3rd gear position. Knock out pin upward far enough that selector rod joint can be pulled off of shaft. |  |
Lubricate joint and bearing bushing with Longterm 2. |  |
