REPLACING DIODE PLATE Remove regulator. Mark installed position of housing (1) and slip ring bearing (2). Detach housing (1) at slip ring bearing (2). Installation: Stick corrugated washer in front of grooved ball bearing with Ft 1 v 34 grease.
Take diode plate (9) with stator (10) off of slip ring bearing (2). Note installed position of washer (11) and insulator (12).
Unsolder diode plate (9) at stator coil (10).
Vehicles after change point in 1982 - Alternator Removed and Disassembled - Unsolder stator coil on diode plate. Caution! Excessive heat from soldering iron would destroy the diodes.
Unscrew bolts. Remove diode plate.
Installation: Check condition of insulating sleeves and insulators.