REPLACING TIMING CASE COVER
RADIAL OIL SEAL
Remove guard.
Hold flywheel with Special Tool 11 2 100.
Use Special Tool 11 2 120 on automatic transmission.

63011145 - click to zoom
 
Remove fan housing.
Slacken drive belts by loosening alternator,
power steering pump and compressor.
Installation: Tighten drive belts - standard belts
should give under thumb pressure applied midway
between two pulleys by 5 to 10 mm (0.197 to 0.394´´)
and open flank belts by 2 to 3 mm (0.080 to 0.120´´).
Unscrew nut¹) on pulley.


Siehe auch ¹) See Specifications
63011149 - click to zoom
 
Pull off vibration damper with hub.
Important: Watch correct location of key (1).
Remove radial oil seal.
Installation: If hub has serious scoring, install
seal that its sealing lip is in front of or behind scored groove.

63011146 - click to zoom
 
Lubricate sealing lip of radial seal with oil.
Press in radial oil seal with Special Tools
11 1 273 and 11 1 272.

63011298 - click to zoom
 
Vehicles after change point in 1982
REPLACING RADIAL OIL SEAL
IN LOWER TIMING CASE
COVER
Remove vibration damper with hub 11 23 000.
Lift out radial oil seal with a screwdriver.


Siehe auch 11 23 000
3011065 - click to zoom
 
Lubricate sealing lip of radial oil seal with oil.
Press in radial oil seal with Special Tools 11 1 273 and 11 1 272.

2811045 - click to zoom