Vehicles after change point in 1982 REMOVING AND INSTALLING TIMING CASE Unscrew Timing case only when engine is cold (coolant temperature max. 35° C/95° F). Disconnect battery ground lead. Unscrew plug and drain coolant. Insatallation: Pour in coolant***.  *** See Service Information of Gr. 00
|  |
 |
|
Pull out cam followers and place them on the tray, Special Tool 11 3 030. Installation: Install cam followers in the same positions. |  |
Unscrew pipe. Remove bolts. |  |
Unscrew timing case. |  |
Installation: Replace O-rings (2) in oil bores. Check O-rings (3), replacing if necessary. Coat sealing surfaces with Silastic**. Tighten bolts uniformly. Tightening torque*. * See Specifications ** Source: HWB
|  |
Measuring Cam Follower Clearance: Measure diameter of cam followers with a micrometer. |  |
Set internal calipers on the micrometer to zero with the measured cam follower diameter. Measure the cam follower bore diameter*. Compare the measured cam follower clearance with the specified cam follower clearance. * See Specifications
|  |
