REMOVING AND INSTALLING STEERING
LOCK/IGNITION SWITCH
Disconnect minus lead at battery.
Remove and install lower casing - 32 31 020.
Unscrew hollow setscrew and remove ignition
switch.
Installation: Turn back ignition key all the way.
Set ignition switch at "0" position and install.


Siehe auch 32 31 020
63061016 - click to zoom
 
Pull off wires for buzzer and horn.
Detach wire straps.
Installation: Check wire straps, replacing if
necessary.

63061013 - click to zoom
 
Disconnect central fuse/relay plate plug (1)
and plug connector (2).

63061018 - click to zoom
 
Vehicles after change point in 1982
Disconnect battery ground lead.
Remove instrument panel trim at bottom left - 51 45 180.
Unscrew steering column casing.


Siehe auch 51 45 180
2832097 - click to zoom
 
Cut open clamp and pull wire harness out of holder.

63061147 - click to zoom
 
Compress retainers.
Push up and disconnect outer plugs.

63061148 - click to zoom
 
Pull off plugs (1and 2).

63061149 - click to zoom
 
Compress retainers.
Pull plug out of holder.

63061150 - click to zoom
 
Unscrew screw (1) and remove plastic holder.
Disconnect plug (2).

63061151 - click to zoom
 
Unscrew headless screw and pull out ignition switch.
Installation:
Lock headless screw with clear lacquer.

3032111 - click to zoom