Vehicles after change point in 1982
REPLACING WIRE HARNESS
FOR ABS
(On M 6, ABS wires are integrated in
main harness.)
Disconnect battery ground lead.
Disconnect ground wire on body.
Disconnect wire on battery positive pole.

63034193 - click to zoom
 
Unscrew wire clamps on body and wire clip on
heather wall.
Disconnect both plugs for front pulse sensor.

63034194 - click to zoom
 
Detach cover on hydraulic unit.

63034185 - click to zoom
 
Unscrew bolts (4 and 5).
Pull off multiple pin plug on hydraulic unit.
Disconnect ground wire.

63034186 - click to zoom
 
Remove rear seat 52 20 010.
Remove left B-pillar trim.
Detach left entrance rail covers.


Siehe auch * See Specifications
2834057 - click to zoom
 
Lift car.
Pull down and disconnect plugs for both pulse
sensors.
Caution!
Do not damage rubber grommets.

2834058 - click to zoom
 
Route wires inwand.
Detach carpet and trim on left side as required.
Pull wires forward in car.

63034187 - click to zoom
 
Detach left trim lower section.
Disconnect plugs (1 and 2).

63034195 - click to zoom
 
Pull wires forward into engine compartment.

63034196 - click to zoom
 
Pull off cap for ABS control unit and plug.
Installation:
First connect left side of plug and then press
right side into clamp.

63034197 - click to zoom
 
Unscrew bolts (1 ... 7).
Detach trim.
Pull wire harness through heater wall from
engine compartment.
Fold open hydraulic unit plug for this step.

63034198 - click to zoom
 
Installation:
Replae damaged rubber grommets.
Check ABS function with BMW service test unit
34 50 000.


Siehe auch 34 50 000
2834078 - click to zoom