Vehicles after change point in 1982
REPLACING REAR MODEL SIGN
The model sign is cemented and cannot be reused.
Coat a nylon string or garn with Tenside (e.g. dish washing detergent) ans "saw through" coat of
cement between trunk lid and model sign.
Remove residual cement with methylated spirits.
Model signs may only be installed at room temperature.
Locate tape up to upper edge "C" and mark distances according to table.
Heat model sign to approx. 40 ... 50°C (105 to 120°F) and press on firmly 5 to 10 seconds.

Distances for Model Signs:

Distances in mm (inch)	A	B	C	D
633 ... 635 CSi	170 (6.693)	15 (0.591)	26 (1.024)	18 (0.709)
III M	61.5 (2.421)	-	26 (1.024)	-

Note:
Model signs must be removed when drying paint in an oven at temperatures above 80°C (175°F).