Vehicles before change point in 1982
ADJUSTING SELECTOR LEVER, ACCELERATOR AND TRANSMISSION CABLES
A) Adjusting Selector Lever
Check tightness of bearing bracket before adjusting.
Selector rod (1) must be attached in hole on selector lever (3) without a code letter.
Detach selector rod (1) at selector lever lower section (2).
Move selector lever (3) on transmission to position O or N.
Press selector lever (4) against stop (5) on shift gate.
Alter length of selector rod (1) until pin (6) aligns with bore in selector lever lower section (2).
Now shorten selector rod length by 1 to 2 turns at pin (6).
Attach and secure selector rod.

C) Adjusting Accelerator Cable (Fuel Injection Engine)
Requirement: correct full throttle adjustment.
Check length of pull rod (1); L = 430 mm (16.929´´).
In neutral, adjust play (S) to 0.25 ... 0.75 mm (0.010 ... 0.030´´) with nuts (2).
Check kickdown stop (5).
Unscrew locknut and tighten kickdown stop (5).
Depress accelerator pedal (6) up to transmission pressure point.
In this position, unscrew kickdown stop until accelerator pedal (6) rests on it.
Press down on accelerator pedal (6) against kickdown (final position).
Adjust push rod (7) that distance (S) from seal (3) to end of cable (4) is at least 45 mm (1.772´´).

Vehicles after change point in 1982
ADJUSTING SELECTOR LEVER;
ACCELERATOR LINKAGE AND
ACCELERATOR CABLE
A) Adjusting Selector Lever
Check tightness of bearing bracket before adjusting.
Selector rod (1) must be attached in bore of selector lever (3) without code letters.
Detach selector rod (1) at selector lever lower section (2).
Move selector lever (3) on transmission to position N.
Press selector lever (4) against stop (5) on shift gate.
Alter length of selector rod (1) until pin (6) aligns with bore in selector lever lower section (2).
Now shorten selector rod length by 1 to 2 turns with pin (6).
Attach and secure selector rod.

B) Adjusting Accelerator Cable
Requirement: full throttle setting correct.
In neutral position adjust play (S) to 0.50 ± 0.25 mm (0.020 ± 0.010´´) with nuts (1).
Check kickdown stop (2).
Unscrew locknut (3) and screw in kickdown stop (2).
Press dorn accelerator pedal (4) to transmission pressure point.
Unscrew kickdown stip in this position until accelerator pedal touches.
Press accelerator pedal (4) to kickdown (final position).
Now distance (S) from seal (5) to end of sleeve (6) must be at least 44 mm (1.732´´).